Author Topic: SilverTron Battery Question  (Read 1066 times)

0 Members and 1 Guest are viewing this topic.

Offline Bobby

  • Expert
  • Participant
  • ***
  • Posts: 721
  • Likes: 21
  • "I walk slowly, but I never walk backward" Lincoln
SilverTron Battery Question
« on: January 02, 2016, 01:36:43 PM »
Kephra,
 
  Got a question on the SilverTron Elite v2 battery backup.

  Can eight 1.2V 10000mAh LSD rechargeable NiMH batteries giving a total of 9.6v 10000mAh input work?

  I also have a dozen Tenergy 9V 250 mAh rechargeable NiMHs.  But that only gives 9V & a low 3000mAh input. Maybe for short runs?

  Will any of these work for aa off grid power supply?  And I do have 18 Duracell D Alkaline.

Thank you, Bobby
"Nearly all men can stand adversity, but if you want to test a man's character, give him power"  Abraham Lincoln

Offline kephra

  • The older I get, the better I was
  • Administrator
  • Participant
  • *****
  • Posts: 7421
  • Likes: 51
  • Illegitimi Non Carborundum
    • The SilverTron Store Colloidal Silver Generators
Re: SilverTron Battery Question
« Reply #1 on: January 02, 2016, 01:44:10 PM »
The SilverTron Elite V2 needs 7 volts minimum, 10 volts maximum to be safe, and it draws about 300mA.
The rechargeable 9 volt batteries would not last even an hour.
Colloidal Silver is only a bargain if you make it yourself.

Offline Bobby

  • Expert
  • Participant
  • ***
  • Posts: 721
  • Likes: 21
  • "I walk slowly, but I never walk backward" Lincoln
Re: SilverTron Battery Question
« Reply #2 on: January 02, 2016, 06:13:53 PM »
Kepra,

 The 9V seem to work fine for those tight places where you need extra light at the wave of a hand. But you are right, not much power there. Also corrected my math on the mAh of the NiMHs.

Thanks, Bobby
"Nearly all men can stand adversity, but if you want to test a man's character, give him power"  Abraham Lincoln

Offline schiaucu

  • Participant
  • **
  • Posts: 50
  • Likes: 0
Re: SilverTron Battery Question
« Reply #3 on: January 18, 2016, 04:16:38 PM »
The input voltage of the Silvertron Elite is 9V and the output 30V? Do you have a little transformer inside? Why don't you power it at 30V?

Offline kephra

  • The older I get, the better I was
  • Administrator
  • Participant
  • *****
  • Posts: 7421
  • Likes: 51
  • Illegitimi Non Carborundum
    • The SilverTron Store Colloidal Silver Generators
Re: SilverTron Battery Question
« Reply #4 on: January 18, 2016, 04:31:06 PM »
Its very difficult and expensive to get 30 volt wall transformers.  9 volt adapters are easy to get.
There is no transformer inside, just a little magic :)
Colloidal Silver is only a bargain if you make it yourself.