SilverTron Support and Scientific Info > SilverTron Notes And Support Questions

320ppm batch to make ...first time

<< < (2/4) > >>

cfnisbet:
I would have thought that a kosher store might have certified kosher beef gelatine. That would be a good place to start, anyway.

Thelegend:
Great Lakes Gelatin Collagen Hydrolysate (Kosher) 454-Grams (Canadian Labelling) https://www.amazon.ca/dp/B07BQBLH69/ref=cm_sw_r_cp_apa_i_PRhyBbB1F6B14

Actually this might not work and I might have to go with the straight gelatin beef option.

So I am thinking to actually form the gelatin has to heat up ...hydrolyzed collagen does not need heat to absorb but I'm not sure if it interacts the same way to stabilize the silver...for instance it's not normally used for gelling things sand the same properties that help stabilize the silver could be the same thing that stabalizes the silver... I'm not a rocket surgeon just yet...perhaps one day when I have time when the kids are grown up

Thanks all!

Thelegend:
So here is what I have and gonna try and hope this works

Modified Kephra's notes

Start with 250ml cold distilled water.
Add 2 grams beef gelatin, let sit for 5 minutes.
Heat with stirring to a simmer.... boiling not necessary. I'll put it in a pot and slowly bring to simmer.
Add 5 drops electrolyte. -Washing soda and distilled water mixture
Add minimum 5 drops Karo corn syrup. Half teaspoon of dextrose
Put it mason jar stick silver and Cath(a)nodes on and set to 320mm 6ma and
Start electrolysis.

Thelegend:
so i couldnt get the silvertron to work properly reading 10 to 20v

first i tried this



Start with 250ml cold distilled water in a 250 ml beaker
Add 2 grams beef gelatin, let sit for 5 minutes.
stirred with a magnetic stirrer
Then heated  to a simmer... on a stove cause the stirrer isnt a hot plate as well
Add 5 drops electrolyte. -Washing soda and distilled water mixture - prob put closer to 7 drops
Add minimum 5 drops Karo corn syrup. Half teaspoon of dextrose ( put in a bit more than half a teaspoon
put the mason jar cap on the beaker popped in both silver to start to the black and the red
Start electrolysis.

could only get about 4 to 5 reading  - the silver rod went reeally black

red a few things about trying a thinner cable

i cut up some coax and stripped it and got better - around 8v

have any suggestions on this? i cant really seperate the nodes apart any further being that it is a thin 250ml beaker. does the electrolye or the dextrose affect the resistance causing a lower voltage or am i missing something?

Ill follow up with some pics too

Thelegend:
and one more of the silvertron settings - its not running at this point but shows the 320 and 6ma

Navigation

[0] Message Index

[#] Next page

[*] Previous page