Author Topic: Confused about when High Setting can be used  (Read 2701 times)

0 Members and 1 Guest are viewing this topic.

Offline frosty305

  • Participant
  • **
  • Posts: 16
  • Likes: 0
Confused about when High Setting can be used
« on: November 11, 2017, 04:55:06 PM »
This is in regards to making 20ppm colloidal silver.  The Silvertron Jr.  Manual states:
SilverTron Jr. has 2 selectable current settings. Use the High setting
if you have a stirring device to keep the solution well mixed, are
processing using a hot plate at near boiling temperature, or have a large
anode of more than a square inch of surface area, such as a bullion bar

My question is can I make the 20ppm using the high setting with only a Magnetic stirrer or do I also need a heated plate (heat source) ?

many Thanks

Offline kephra

  • The older I get, the better I was
  • Administrator
  • Participant
  • *****
  • Posts: 7428
  • Likes: 51
  • Illegitimi Non Carborundum
    • The SilverTron Store Colloidal Silver Generators
Re: Confused about when High Setting can be used
« Reply #1 on: November 11, 2017, 06:19:00 PM »
Heating is not required to make 20 ppm colloidal silver.  So just use your stirrer, and put your Jr on high.
You want a vortex in the water that is at least an inch deep, preferably more.
Colloidal Silver is only a bargain if you make it yourself.