Author Topic: SilverTron - microwave before electrolysis  (Read 2256 times)

0 Members and 1 Guest are viewing this topic.


  • Guest
SilverTron - microwave before electrolysis
« on: June 01, 2015, 07:14:23 PM »
Is it okay to heat up the distilled water by microwave to make colloidal silver with the Silverton?

Offline kephra

  • The older I get, the better I was
  • Administrator
  • Participant
  • *****
  • Posts: 7428
  • Likes: 51
  • Illegitimi Non Carborundum
    • The SilverTron Store Colloidal Silver Generators
Re: microwave before electrolysis
« Reply #1 on: June 01, 2015, 07:24:35 PM »
Colloidal Silver is only a bargain if you make it yourself.


  • Guest
Re: microwave before electrolysis
« Reply #2 on: June 01, 2015, 08:56:44 PM »
I heat my DW in microwave for 4 minutes first then add electrolyte and electrolysis for about twenty minutes then reduce with karo , on stove in pan of almost boiling water for about 10 -15 minutes. I don't know if the last step ( with heat) is necessary but I used this method prior to reading the recipe here in the articles. One of my early batches which turned out dark but pretty good I used maple syrup which I added with electrolyte before electrolysis. It was homemade syrup so it was reasonably pure. I reduced with heat, in pan of water as described above and it darkened as I watched. I haven't tried to make capped colloidal silver yet. Don't have stirring system set up yet but I think I was making higher than 20 ppm colloidal silver accidentally by added the sugar early. One of Kephras recipes outlined similar method.