Colloidal Silver and Gold Forum

Production Techniques and Chemistry => SilverTron Notes And Support Questions => Topic started by: Lefteris on November 05, 2014, 11:38:55 AM

Title: Size question of Polyethylene Lid/electrode holder for Mason Jar
Post by: Lefteris on November 05, 2014, 11:38:55 AM
Would anyone know of what would be a good inner opening mouth diameter of a jar to be used with this holder?
Title: Re: Size question of Polyethylene Lid/electrode holder for Mason Jar
Post by: kephra on November 05, 2014, 12:01:56 PM
60mm to 65mm would be ideal

Here is what I make:
(http://www.cgcsforum.org/pix/NewLid1.jpg)

The inside raised portion fits inside a standard Mason/Ball Jar.  The outside raised portion fits on the outside of a widemouth Mason/Ball jar.

So you should be able to find jars which fit inside the milled out ring.
If not, you can just turn it upside down until you make a new electrode holder.  The electrode spacing is 37mm.